PCBFUN STC-3000 DC12V 24 โวลต์ AC110V-220V ควบคุมอุณหภูมิดิจิตอลเทอร์โมเซ็นเซอร์ที่มีการสอบสวน

Instruction:
Switch the modes between cool and heat;
Control temperature by setting the temperature setting value and the difference value;
Temperature calibration;
efrigerating control output delay protection;
Alarm when temperature exceeds temperature limit or when sensor error.

Specification and Size:
Front panel size: 75(L)x34.5(w)(mm)
Mounting size: 71(L)*29(W)(mm)
Product size: 75(L)x34.5(W)x85(D)(mm)
sensor length: Im (include the probe)

Technical Parameters:
Temperature measuring range: 50°C~99°C
Resolution: 0.1°C
Accuracy: +1°C(-50°C~70°C)
sensor error delay: l minute
Power supply: AC 110V-220V 50/60Hz
Power consumption: <3w
Sensor: NTC sensor (IPC)
Relay contact capacity: Cool(10A/250VAC); Heat(10A/250VAC)
Ambient temperature: 0°C~60°C
Storage temperature: -30°C~75°C
Relative humidity: 20-85%(No condensate)
Key operation instructructiom

1. View parameter method
When the controller is working normally press and release the “▲” button once Display the temperature set value press and immediately release the “▼” button once to display the temperature difference set value 2 seconds Return to normal temperature display state
2. Set the parameter method
When the controller is working normally press and hold the “S” button for more than 3 seconds to enter the modified parameter mode “Set The indicator light is on and the digital tube displays the code F1 of the first menu item.
Press “▲” or “▼” to scroll up or down the menu item and display the menu code press “S”
The key displays the parameter setting value of the current menu. Hold down the “S” key and press and hold “▲” or “ the key can be adjusted up or down and the parameter setting value of the current menu is displayed while holding down S and ▲
The key or “▼” key can quickly up or down and display the parameter settings of the current menu.
After the completion press and release the power button to save the parameter modification and return to the normal temperature display state.
If there is no key operation within 0 seconds the parameter modification will not be saved and return to the normal display state.
“Er” is displayed if an error occurs while saving the parameter and returns to the normal display state after 3 seconds.

3.Repair system data
When the machine is powered on first check whether the parameter setting is normal. If the check is wrong it will display “ER”. Pressing any key at this time will restore the default parameter settings and work normally. It is recommended to reset the parameters at this time.

Package:
1 x STC-3000 Digital Temperature Controller Thermostat With Sensor