4Axis CNC USB MACH3 100Khz Breakout Board บอร์ดควบคุมเครื่อง CNC Mach3

Specifications
Product type : 4 Axis CNC Breakout Board
Interface : USB
Maximum step-pulse frequency: 100 KHz
Automatic probe tool Support: Yes
Emergency input: Yes
Limit switches: Yes (4 general-purpose inputs you can connect the limit switch estop switch probe switch back to zero and other device)
External Voltage: 12V/24V
Spindle Control Output: Yes (0-10V output port)
Size: 8×7.7cm /3.15×3.03inch
Tested with following Operating Systems:
Windows XP (direct)
Windows 7 64bit /32Bit (direct)
Windows 10 (Indirect using Windows XP on VmWare)

Setup Instructions
Step 1: Install Mach3: If you already have a Mach3 Installed skip this step.
Step 2: Download the USB Motion Driver RnRMotion.dll from the link down below and copy and paste the file into your Mach3 Plugins folder Example: “C:/Users/ProgramFiles/Mach3/Plugins”
Step 3: Make sure you board is connected to the PC via USB cable. It should automatically recognize the USB device.
Step 4: Open Mach3 and you should be prompted to select a driver. Select the “RnRMotionController” and check “Don’t ask me again”. This will allow your board to communicate with Mach3.
Step 5: Download the XML Mach3 Config File above by right clicking on the link and selecting “save as”. Save the Mach3Mill.xml file in your Mach3 root folder.

1 x บอร์ด Mach3
1 x สายUSB
1x CD โปรแกรม และไดรเวอร์