The Triton Audio FetHead is a low-noise high quality in-line microphone preamplifier. It provides improved sound for ribbon and dynamic microphones. The electronics are housed in a robust metal chassis with a balanced 3-pole female XLR input and a balanced 3-pole male XLR output rugged enough for use at home in the studio or on tour.

All tested microphones showed sonic improvement. A Shure SM57 for instance sounds more responsive over a broader frequency range. When mated with a high-end dynamic microphone like a Sennheiser MD441 or Shure SM7 FetHead really shines. Ribbon microphones benefit greatly too because of a much better impedance match which lessens the load on the microphone giving it better transient response characteristics. FetHeads high quality low noise signal amplification also extends the usable range of a ribbon microphone making it more suitable for recording softer passages.

Some ribbon microphones do not tolerate phantom power. FetHeads circuit uses 48 V phantom power but shields it from the microphone so the microphone is protected.

FEATURES:
For ribbon and dynamic microphones
Ultra low noise Class A JFET amplifier
27 dB of clean gain
Allows your mic to perform under no-load condition
Easy install - 2 clicks and done
Lowers the noise floor of your recordings
Shielded enclosure
4 matched JFets